Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 46 / 128

12 SERVICE WORK ON THE CHASSIS
44
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on
the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean and oil the dust boots and inner fork tube of both fork legs.
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Position the fork protection. ( p. 44)
–
Remove the motorcycle from the lift stand. ( p. 43)
12.5 Loosening the fork protection
C00564-10
–
Remove screws
1
and take off the clamp.
–
Remove screws
2
on the left fork leg. Push the fork protection downwards.
–
Remove the screws on the right fork leg. Push the fork protection downwards.
12.6 Positioning the fork protection
C00564-11
–
Position the fork protection on the left fork leg. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the brake line and clamp. Mount and tighten screws
2
.
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
12.7 Removing the fork legs
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 82)
–
Raise the motorcycle with the lift stand. ( p. 43)
–
Remove the front wheel.
x
( p. 75)
C00577-10
Main work
–
Remove screws
1
and take off the clamp.
–
Remove cable binder
2
.
–
Remove screws
3
and take off the brake caliper.
–
Hang the brake caliper and the brake line loosely to the side.