Instruction book Rose
37
1.
Snap on the buttonhole sensor
foot. Make sure that the cable is
firmly plugged into the yellow
socket (see picture). The
symbol will flash until a
buttonhole is selected.
2.
Select a buttonhole on the stitch
panel. The buttonhole will be pre-
set for a 16 mm button when the
machine is turned on. The
number 16 is therefore shown on
the display in place of the stitch
length together with the symbol
.
3.
If you are using a different size
button, measure the button on the
buttonhole rule below and set the
correct size with the stitch length
buttons (+) or (-). The size will
change by 2 mm at a time.
4.
Turn the measurement wheel so
that the white area is lined up
with the white mark. When the
measurement wheel is correctly
set, the circle in the
symbol
will stop flashing.
If the circle or the whole symbol
is flashing the machine can
not be started.
Buttonhole sensor foot
The buttonhole will be sewn in
one step, and when the button-
hole is completed the machine
will stop automatically.
Buttonhole size
5.
The machine will sew the correct
size buttonhole for the
button
size
you have selected.
Place the button as shown on the
circles on the picture and you can
easily see the size needed for your
buttonhole.
Changing the density/stitch
length
To change the stitch density of the
buttonhole columns, adjust the
length setting of the stitch. Unplug
the buttonhole sensor. The stitch
length will then be shown on the
Infodisplay again and you will be
able to adjust the density of the
buttonhole. When you plug in the
buttonhole sensor foot, the display
goes back to showing the size of
the buttonhole, but remembers the
new stitch length setting.
8 12 16 20 24 28 32 36 40 44 48
0 6 10 14 18 22 26 30 34 38 42 46 50
Se
wing
