UltraScan PRO Supplemental Manual for EasyMatch QC Ver. 2.0
15
Figure 14. Request 30-day Trial
Add the Sensor
1.
Upon initial startup, the following message will be displayed
: SENSOR NOT YET
INSTALLED. PLEASE INSTALL A SENSOR TO TAKE MEASUREMENTS.
This message will
remain until you proceed to the Install/ Configure command in the Sensor menu and
install a new sensor.
2.
The Sensor Manager appears first:
Figure 15. Sensor Manager
3.
Select
ADD SENSOR
to install a new sensor. The Setup Sensor screen allows selection of
the instrument model and the communications port. Select
NEXT
when ready.
Note: If using a typical 9-pin serial cable for communications between the sensor and
PC, select COM1. If using USB-to-serial adapter, then select the highest number COM
Port No. offered.
