OPERATION
19
Problem
Solution
The blind operates using
the manual control button
but does not operate
using the remote control
in the RF (group) operating
mode.
Be sure the blind operates properly in the infrared mode.
■
The Group feature will not work correctly if the infrared
mode does not work correctly.
Be sure the blinds have been correctly programmed
■
to the remote control you are using. If your remote
control has not been set up to operate your blinds, only
the infrared mode will work. See the information about
assigning blinds to a group in the
Platinum
™
Technology
Remote Control Guide
or the
Platinum Technology
Wireless Wall Switch Guide
.
Blind(s) in a group
are tilting in opposite
directions.
Remove the problem blind(s) from the installation brackets
■
and locate the motor unit at the end of the headrail.
Find the small metal switch on the top of the motor
➤
unit that has a molded "R" and "L" on either side.
Use a small screwdriver, the end of a paper clip, or
➤
similar tool to move the switch to the opposite side.
The motor operates, but
the slats do not tilt.
Check that no obstructions inside the headrail are
■
preventing the tilting mechanism from turning.
Check that the tiltrod is completely snapped into the motor.
■
The slats do not tilt
completely.
Check for obstruction that may be interfering with slat
■
movement.
Motor operation is slowing;
slats tilt slower than before.
Replace the batteries in the satellite battery pack.
■
See page
17, Changing the Batteries in the Satellite Battery Pack.
It is difficult to reach the
satellite battery pack to
change the batteries.
Satellite battery packs with wire lengths up to 8' are
■
available.
See page 1 for size availability
.
The remote control is lost.
Contact your dealer for a replacement remote control.
■
Use the manual control button until the remote control is
■
received.
See page 17, Using the Manual Control Button.
Switch
Top View
Motor
Unit
