OPERATION
16
Raising and Lowering the Blind
Important:
Whenever raising or lowering the blind, the slats
must be in the open position.
Pull the single cord down and toward the
■
center to raise and lower.
Hold the cord to the outside to
■
lock the blind in position.
PowerTilt
™
with Platinum
™
Technology Operation
Infrared (IR) “Point and Press” Operation.
■
With IR operation, a focused infrared beam
from the remote control provides the signal to tilt the slats. IR is a
line of sight
technology;
the beam must be continuous from the remote control to the satellite eye.
Radio Frequency (RF) “Group Mode” Operation.
■
With RF operation, radio frequencies
are used to provide the signal to tilt the slats. RF can be used to control a selected group of
blinds that are either in view or out of view.
Platinum
™
Technology Remote Operation
For information regarding operation and programming of the
Platinum
™
Technology remote control, refer to your
Platinum
Technology Remote Control Guide
.
Platinum Technology Wireless Wall Switch Operation
For information regarding operation and programming of
the Platinum Technology wireless wall switch, refer to your
Platinum Technology Wireless Wall Switch Guide
.
Home Automation Control Using the Connection Interface
For information about integrating PowerTilt
™
operation with a home automation or lighting
system, refer to the
Connection Interface Installation Guide
.
Pull Cord
Toward Outside
to Lock
Pull Cord
Toward Center to
Raise and Lower
Raising and
Lowering
