INSTALLATION
13
Complete the Installation
Attach the Valance Returns (If Necessary)
If the valance came with returns and they are not already
attached, connect the returns to the valance using the
corner clips provided.
The notches on the rear of the valance and returns
■
fit into the grooves of the corner clips.
Slide one end of each clip onto the rear of the
■
valance until the center of the clip aligns with the
edge of the miter cut at each end.
Slide a return onto each corner clip until its miter is
■
flush against the miter on the valance.
Splice Valances
For valances that are spliced and did not come with a
decorative keystone, adjoin the two mitered valance
pieces together by sliding the valance splice clip onto the
back of the valance where the two halves meet.
Decorative Keystone
Wood Blinds Only
If a decorative keystone was ordered, splice
it to the two angled valance pieces.
Firmly press the two pieces together.
■
Anchor them in position using the provided
set screws. Secure the screws into the
back of the valance through the holes in
the keystone.
Repeat the procedure for the other angle.
■
Miters Meet
Corner
Clip
Valance
Valance
Return
(Cross-
Section)
Notch
Notch
Valance
Splice Clip
Miters
Angle Cut Valance Pieces
Keystone
Set Screw
