INSTALLATION
6
Mount the End Brackets – Outside Mount
A flat vertical surface at least 1
3
/
4
" high is required for bracket
attachment.
Mark where the ends of the headrail will
■
be located.
Either hold the headrail up to the
■
mounting surface or measure
the headrail and mark its
width.
Then mark ¼" to
■
the outside of the
headrail end marks.
Attach End Brackets
Align the outside edge of each bracket with the
■
outer marks.
The tops of the brackets must be aligned at the
■
same height.
Mark the location of the holes for the screws.
■
The brackets will be attached with two screws
➤
through diagonal rear holes.
Using a
■
3
∕
32
" drill bit, drill holes for the mounting screws.
Important:
If you are fastening the end brackets to drywall, be sure to use wall anchors
and follow the instructions provided with the anchors. (Anchors not provided.)
Use a level to check that the mounting surface is level. Shim the brackets if necessary.
■
Use the hex head screws provided with your order to fasten the installation brackets to the
■
mounting surface.
Important:
The front edges of the installation brackets must align to each other.
Mark
Mark
Measure and mark
¼" out from
ends of headrail.
