Hughes HX90, Installation Manual, Page: 41 / 124

Chapter 4 • Commissioning the satellite router
1039456-0001 Revision A
41
4. If you plan to use an antenna pointing tool, select DAPT , OPI , or N/A (for none)
from the Antenna Pointing Tool drop-down list.
For Ka-band select DAPT ; for Ku-band a DAPT or OPI may be used.
5. Click
Next
.
Note: There is no verification screen when you manually enter the satellite
parameters.
Entering radio parameters
1. On the Receive LNB Selection screen, select the installed LNB from the Receive
LNB drop-down list (Figure 22 on page 42).
The list of LNBs you see depends on the how the router is configured, based on
its
sbc.cfg
file.
Select the LNB option that matches the part number or other identifier on the
installed LNB. If you cannot find the LNB part number or identifier, refer to the
LNB illustrations in LNB selection reference on page 109 for guidance. If you are
not sure which LNB option to select, contact Installer Support.
Make sure you select the correct LNB. If you select the wrong LNB, the satellite
router will not work.
NOTICE