Hughes HX90, Installation Manual, Page: 39 / 124

Chapter 4 • Commissioning the satellite router
1039456-0001 Revision A
39
The Verification of Satellite Parameters screen appears.
Figure 19: Verifying the satellite parameters screen
3. Verify that the displayed information is correct and click
Next
.
If the parameters are not correct for the installation, click
Back
to change the
satellite transponder selection.
4. If you plan to use an antenna pointing tool, select DAPT , OPI , or N/A (for none)
from the Antenna Pointing Tool drop-down list.
For Ka-band select DAPT ; for Ku-band a DAPT or OPI may be used.
5. Click
Next
.
Entering satellite parameters (manual entry)
This is an alternate method for entering the satellite parameters. You must use this
method if the satellite and transponder for your installation are not listed in the
drop-down list in Figure 18 on page 38
and you were not provided with an
sbc.cfg
file.
Skip this section if you selected a satellite and transponder on the Satellite
Parameters screen.
The satellite parameters are provided to you in a technical update email or in an
installation specification.
To enter the parameters:
1. On the Satellite Parameters screen, select the Enter satellite parameters
manually checkbox shown in Figure 18 on page 38.