9502 User Guide
3004146-0001 Rev H
61
To adjust azimuth, refer to Figure 4-15 - Adjusting azimuth
4.
Loosen the two bolts on the pole collar.
5.
Move the ODU to either side, in small increments, as
necessary to get the optimum signal strength as shown on the
voltmeter or by the fast high pitch sounds that you hear with
the headphones.
When you have maximized the signal quality:
6.
Tighten the two bolts in the curved slots on the azimuth
elevation bracket to lock down the elevation adjustment.
7.
Be careful not to change the ODU’s orientation while
tightening the bolts.
8.
Tighten the two bolts on the pole collar to lock down the
azimuth adjustment.
9.
Make sure all other fasteners on both brackets are tight.
Exit Pointing Mode
1.
Short press the function button (<2 seconds) to exit pointing
mode. The terminal will initiate registration with the network.
2.
Verify the unit registers, attaches, and establishes a PDP
context by checking the status on the Web UI or when all three
of the LEDs are solid green (Figure 4-13 – LED Flow Chart).
3.
Optionally, verify the unit will correctly recover from a power
cycle by removing and reapplying power. Verify it registers,
attaches, and establishes a PDP context by again checking the
status on the Web UI or when all three of the LEDs are solid
green (Figure 4-13 – LED Flow Chart).
4.
Verify end to end connectivity of the system, by sending a
small amount of data from the device connected to the 9502
and verifying that the data was received by the other end (e.g.,
data center).
