20
9502 User Guide
3004146-0001 Rev H
Status Bar
The status bar is included on the home page and other pages that
do not have a navigation bar. It includes a field with the elevation
angle and compass direction towards the visible satellite(s).
The status text in the
Connection
section is as shown in Table 3 –
Status Bar below.
Display
Comments
Corresponding LED
display
Initializing
Initial start up (~15-20 secs) Various
Pointing
UT in pointing mode
All three LEDs flash 1Hz
Registering
Attempting to register -
pointing mode exited or
bypassed
PWR on, GPS on or
flashing, NET off
Registered
Registered and attached,
no context
PWR on, GPS on and
NET flashing
Connected
PDP context active
All three on (or off after 1
minute timeout)
Table 3 – Status Bar
The signal strength bar shows the quality of the received signal.
The same scale is used for all beam types and so during pointing
only the left part of the bar is used. The signal strength in the
Global Beam should be 49 to 53dB when it is pointed correctly
(the higher the better). It also lists the current satellite beam type
and number. In release 5.9.5.0 and higher the current satellite is
also shown.
The signal strength increases in value as you transition to the
Regional Beam and again when you get a PDP context and
transition to the Narrow Beam.
The
GPS
status area shows the status of the GPS fix and results are
shown in the following table:
Display
Comments
Acquiring
Trying to acquire a GPS fix
Stored
UT is using a Stored GPS fix
2D GPS Fix
The UT has acquired a 2D GPS fix and can continue
Registration with the network
3D GPS Fix
The UT has acquired a 3D Fix
Location
Shows Latitude and Longitude coordinates if allowed
by network GPS Policy.
Shows “Blocked” if the unit has a fix but the policy has
not yet been received from the network.
Last Fix
Shows date and UTC time of last GPS fix
Table 4 – GPS Status
The
Pointing Info
section shows the satellite that the UT should be
pointed to and the Azimuth and elevation angles to the satellite.