Hughes Network HN9260, Installation Manual

Page: 49 / 122

Chapter 4 • Commissioning the satellite modem
1039434-0001 Revision A
49
Note: If you open the pointing validation screen before antenna pointing is
complete, a message appears (instead of the text shown in the screen
illustration above) asking you to wait until pointing is complete. The message
advises that if you exit antenna pointing without passing final validation,
the
transmitter will be disabled .
Note: The Results Saved field indicates whether you saved the pointing values or not
when the DAPT prompted
Store Results?
near the end of the squinter
pointing process.
7. This step depends on the validation test results:
•
If any validation test fails , click
Back
to restart DAPT antenna pointing; then
re-test until all tests pass.
•
If you are using satellite-based commissioning and all four validation tests
pass, click
Next
to continue.
Note: The
Next
button shown in Figure 30 is present only if final validation is
successful. If any test failed, only the
Back
and
Exit
buttons are present.
• If you are following the instructions for Ka-band manual commissioning and
all four validation tests pass, this is the last step; click
Exit
.
When all four validation tests have passed, Ka-band pointing is complete and
validated.
Receive antenna pointing - Ku-band
Note: This section applies to Ku-band installations only. For Ka-band, skip this
section; go to Registering the satellite modem on page 53.
Follow these steps to receive-point the antenna using the displayed signal
strength, as shown in
Figure 31 . Adjust the antenna to point it as instructed in
the antenna installation guide.