Troubleshooting
57
Gateway rear panel
Ethernet LEDs
Each of the four Ethernet ports on the Gateway has two LEDs associated with it.
One LED is green and one is yellow. See Figure 53.
The green LED will be on if power is applied to the Gateway and a 100baseT
Ethernet device is connected to the corresponding Ethernet port. Otherwise, the
green LED will be off.
The yellow LED will also be on when power is applied to the Gateway. It will
flash momentarily when there is LAN activity on the corresponding Ethernet
port.
If the green or yellow LEDs are not lit, take the following steps.
•
Unplug the Ethernet cable from the Gateway and plug it back in.
•
If the LEDs still do not come on, power cycle the DW4020 by unplugging
the power cord from the wall outlet or surge protector, waiting ten seconds,
and plugging it back in.
•
If the LEDs still do not come on, try using a different Gateway LAN port.
•
If the problem persists, contact your service provider.
Figure 53: Gateway Ethernet LAN port LEDs
Green LED
Yellow LED
Summary of Contents for DirecWay DW4020
