ThurayaIP Satellite Modem User Manual
9
I
MMI S
TATUS
/M
ENU
D
ISPLAY
S
UMMARY
The upper level of the LCD displays
status messages
and
menu items
.
Status messages are summarized in the table below.
Display
Description
Powering Off
Displayed while
Thuraya
IP
is powering down
Fault {code}
A hardware fault exists, prev enting operation (see
troubleshooting section for code explanations)
Too Hot
A temporary thermal shutdown is about to occur
Battery Hot
A temporary thermal shutdown is about to occur
due to battery heating
No SIM
No SIM is detected in
Thuraya
IP
Locked
A security code is needed (entered v ia wMMI)
PIN
A SIM pin code is needed (entered v ia wMMI)
Pointing
In pointing mode
GPS old
GPS is older than the system time period allows
Disconnected
PDP connection is disconnected, preventing data
transfer
Tx{rate}/Rx{rate}
Transmit and Receiv e streaming rates in kilobits per
second
Standard
Best efforts quality of serv ice in both directions
G
ENERAL
N
AVIGATION OF THE I
MMI
You navigate among the options available in the iMMI by utilizing the
Menu
and
Modify
buttons. With the unit in its “normal” state displaying
status indicators, you press the Menu button to view and modify
Quality
of Service (QoS)
settings and
LCD
display parameters. Pressing the
Modify button within a Menu option allows you to change the current
setting.
The status display is the default display; after 30 seconds of inactivity, the
display always reverts to the status display. Pressing the Menu button
takes you through a circular list of menu items and then back to the
status display. The two major menu options are the following:
Change Rate
: Modify the QoS settings for Transmit and Receive.
LCD Contrast
: Modify the contrast on your LCD.
Summary of Contents for ThurayaIP
Page 2: ......
