Configuration manual EGS(H)41
13
3.2
Information section
Information from the connected EGS(H)41 is displayed in the information section.
The previously mentioned dynamic indicator symbolizing the communication status between the PC
and the EGS(H)41 is displayed in the middle. Each successfully transmitted or received data packet
causes the partial ring to rotate.
3.3
Display section
The display section is located on the left-hand side of the screen, where it possible to check the set-
tings transmitted to the EGS(41). The current speed and direction of rotation of the EGS(41). are dis-
played in the top part of the display section.
Below that the speed(s) settings are displayed in table form.
The abbreviations are explained in the chapter 4 on the 'Parameters 1' page.
ATTENTION!
The values displayed in the table always correspond to the current device settings!
Below the table a graphic displays the switching statuses of the safe outputs 'S1, S2' and the diagnos-
tics output 'Diag.'.
ATTENTION!
The graphical symbols always represent the defined setpoint value!
Graphic symbols depicted in red indicate that switch position determined by the
EGS(H)41 does not match the programmed switch position.
