Step 3
Run the following command as required:
l
Run:
apply cost
[
+
|
-
]
cost
The cost of the route is set.
l
Set the cost type of the route.
–
Run the
apply cost-type
{
external
|
internal
} command to set the cost type of an IS-
IS route.
–
Run the
apply cost-type
{
type-1
|
type-2
} command to set the cost type of an OSPF
route.
The
apply cost-type
{
external
|
internal
} command and the
apply cost-type
{
type-1
|
type-2
} command are mutually exclusive and cannot be configured at the same time.
l
Run:
apply ip-address next-hop
{
peer-address
|
ipv4-address
}
The next hop address of the IPv4 route is set.
l
Run:
apply ipv6 next-hop
{
peer-address
|
ipv6-address
}
The next hop address of the IPv6 route is set.
l
Run:
apply isis
{
level-1
|
level-1-2
|
level-2
}
The route level of IS-IS is set.
l
Run:
apply ospf
{
backbone
|
stub-area
}
The area of the OSPF that routes are imported into is set.
l
Run:
apply preference
preference
The preference of the routing protocol is set.
The smaller the preference value, the higher the preference.
l
Run:
apply tag
tag
The tag of the route is set.
The commands in Step 3 can be used regardless of the order.
----End
10.4.5 Checking the Configuration
After the Route-Policy is configured, you can check information about the Route-Policy.
Prerequisites
The configurations for the Route-Policy are complete.
Procedure
l
Run the
display route-policy
[
route-policy-name
] command to check the Route-Policy.
----End
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
10 Routing Policy Configuration
Issue 01 (2012-03-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
601
