l
Set the negotiation mode in which P2P neighbor relationships can be set up.
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
The interface view is displayed.
3.
Run:
isis ppp-negotiation
{
2-way
|
3-way
[
only
] }
The negotiation mode is specified on the interface.
By default, the
3-way
handshake negotiation mode is adopted.
The
isis ppp-negotiation
command can only be used for the establishment of the
neighbor relationships on P2P links. In the case of a broadcast link, you can run the
isis circuit-type
p2p
command to set the link type to P2P, and then run the
isis ppp-
negotiation
command to set the negotiation mode for the establishment of the
neighbor relationship.
l
Configure OSICP negotiation check on PPP interfaces.
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
The interface view is displayed.
3.
Run:
isis ppp-osicp-check
The OSICP negotiation status is checked on a PPP interface.
By default, the OSICP negotiation status of a PPP interface does not affect the status
of an IS-IS interface.
The
isis ppp-osicp-check
command is applicable only to PPP interfaces. This
command is invalid for other P2P interfaces.
After this command is run, the OSICP negotiation status of a PPP interface affects the
status of an IS-IS interface. When PPP detects that the OSI network fails, the link
status of the IS-IS interface goes Down and the route to the network segment where
the interface resides is not advertised through LSPs.
l
Configure IS-IS not to check whether the IP addresses of received Hello packets are on the
same network segment.
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type
interface-number
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
6 IS-IS Configuration
Issue 01 (2012-03-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
293
