Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches
Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-18
Table 4-31
Defining information source
Operation
Command
Define information source
info
-
center source
{
modu
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
} [ {
log
|
trap
|
debug
}* {
level
severity
|
state
state
}* ]
Cancel the configuration
of information source
undo info
-
center source
{
modu
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
}
modu-name
specifies the module name;
default
represents all the modules;
level
refers to the severity levels;
severity
specifies the severity level of information. The
information with the level below it will not be output.
channel-number
specifies the
channel number and
channel-name
specifies the channel name.
When defining the information sent to Telnet terminal or dumb terminal,
channel
-
number
or
channel
-
name
must be set to the channel that corresponds to
Console direction.
Every channel has been set with a default record, whose module name is
default
and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
When there are more than one Telnet users or monitor users at the same time, some
configuration parameters should be shared among the users, such as module-based
filtering settings and severity threshold. When a user modifies these settings, it will be
reflected on other clients.
Note:
If you want to view the debugging information of some modules on the switch, you must
select
debugging
as the information type when configuring information source,
meantime using the
debugging
command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
