Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches
Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-13
Operation
Command
Cancel the configuration of
outputting information to loghost
undo info-center loghost host
-
ip
-
addr
Note:
Ensure to enter the correct IP address using the
info
-
center loghost
command to
configure loghost IP address. If you enter a loopback address, the system prompts of
invalid address appears.
3)
Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view.
Table 4-22
Defining information source
Operation
Command
Define information source
info
-
center source
{
modu
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
} [ {
log
|
trap
|
debug
}* {
level
severity
|
state
state
}* ]
Cancel the configuration of
information source
undo info
-
center source
{
modu
-
name
|
default
}
channel
{
channel
-
number | channel
-
name
}
modu-name
specifies the module name;
default
represents all the modules;
level
refers to the severity levels;
severity
specifies the severity level of information. The
information with the level below it will not be output.
channel-number
specifies the
channel number and
channel-name
specifies the channel name.
When defining the information sent to the loghost,
channel
-
number
or
channel
-
name
must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is
default
and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
