6
Securing to the Floor or Base
3.4
Removing Compressor Fasteners
3.3
Lowering a Fan (Applicable to Downflow Units)
3.5
1.Remove the six screws and then the beam.
2.Rotate the fan upward by 30 degrees, and pull
the rotating shaft of the fan to the outermost side.
4.After the fan rotates to the position shown in the
figure, push the fan back to the horizontal position.
5.Use a torque wrench to secure the two beams,
and interconnect the fan cables using the
interconnection terminal reserved in the cabinet.
3.Slowly rotate the fan by 90 degrees and ensure that
the rotating shaft of the fan is on the outermost side.
Exercise caution when handling the fan to avoid body
injury.