15
Installing the AP
Connecting the feed line
(1) The outdoor AP's antenna ports already have 5 KA surge protection capability. Generally, no surge
protection devices need to be installed; therefore, the antenna cables are directly connected to the AP's
antenna ports.
(2) If higher surge protection capability is required, the customer can purchase a surge protection device.
When installing the surge protection device, ensure that it is connected to a ground cable.
Feed line
Waterproof adhesive tape
Surge
protection
device
Feed line
Waterproof
adhesive
tape
Ground cable
a
b
c
NOTE
When no antenna is installed on the 5G antenna interface, cover the interface with a dustproof
cap and wrap the dustproof cap with insulating tape and waterproof tape.
Wrap the feed line using one-layer PVC black insulation tape, three-layer waterproof adhesive
tape, and then three-layer PVC black insulation tape.
Stretch the waterproof adhesive tape evenly and ensure that the upper layer of the tap overlaps
1/2 of the lower layer. Each layer should be attached tightly.
Wrap the three-layer waterproof adhesive tape from bottom to up, from up to bottom, and from
bottom to up in order.
Connecting optical fibers
(1) The right figure shows the appearance of the optical fiber
：
(2) The optical fiber connection of AP6610DN-AGN is similar to that of WA653SN. Here, WA653SN is
used as an example. Connect the optical fiber to the AP and ensure that the waterproof connector is
fastened.
b
c
d
e
f
NOTE
Install an optical module as shown in step a before connecting the fiber.
a
b
c
d
e
f
