IGNITION SYSTEM
6 - 8
4. Ignition spark gap
OUT OF SPECIFICATION OR
NO SPARK
5. Spark plug cap resistance
• Remove the spark plug cap.
• Connect the pocket tester (
Ω
× 1k) to the
spark plug cap.
• Check that the spark plug cap has the
specified resistance.
Spark plug cap resistance
10 k
Ω
at 20 °C (68 °F)
6. Ignition coil resistance
•Disconnect the ignition coil connector from the
wire harness
• Connect the pocket tester (
Ω
× 1) to the
ignition coil.
Tester (+) lead
→
Orange lead terminal
Tester (–) lead
→
Ignition coil base
• Check that the primary coil has the specified
resistance.
INCORRECT
Repair or replace the spark plug.
• Disconnect the spark plug cap from the spark
plug.
• Connect the pulse ignition spark checker or
ignition checker
①
as shown.
②
Spark plug cap
• Turn the main switch to “ON”.
• Check the ignition spark gap
○
a
.
• Crank the engine by pushing the starter
switch, and increase the spark gap until a
misfiring occurs.
Minimum spark gap
6.0 mm (0.24 in)
MEETS SPECIFICATION
The ignition system is not faulty.
MEETS SPECIFICATION
OUT OF SPECIFICATION
Replace the spark plug cap.
Summary of Contents for UTV 700 2009
