HTP Pro Pulse 300, Owner'S Manual

Page: 28 / 37

28
HTP 24 Series MIG Welding Gun
Relatively lightweight and fits into most small spaces. Available in 10’, 12’, and 15’ lengths. For pulse welding, we
recommend a maximum torch length of 10’. For any kind of pulse welding, CuCrZr contact tips should be used.
Failure to do so will result in premature tip wear, poor weld quality, burn backs, birds nesting, and other problems.
The 24 Series MIG Welding Gun can be used for:

Steel (all diameters and thicknesses; both pulse and non-pulse)

Flux-cored (all thicknesses; with or without gas)

Stainless Steel and Silicon Bronze (all thicknesses)
 Aluminum (up to 1/4” material thickness; ONLY 5356 wire in .035” wire diameter, and ONLY if the gun length
does not exceed 10’)
Part# Description Part# Description
24023-10 .023” Contact Tip, 10-Pack 24105B Conical Nozzle, 3-Pack A. E.
24030-10 .030” Contact Tip, 10-Pack 24108B Small Conical Nozzle, 3-Pack A. F.
24035-10 .035” Contact Tip, 10-Pack 24002-DIF Gas Diffuser A. G.
24045-10 .045” Contact Tip, 10-Pack 24002-TH Tip Holder A. H.
24030-10CR .030” CRZR Contact Tip, 10-Pack 24002 Swan Neck A. I.
24035-10CR .035” CRZR Contact Tip, 10-Pack 24100 10’ MIG Gun A. J.
24040-10CR .040” CRZR Contact Tip, 10-Pack 24120 12’ MIG Gun A. J.
A. 24045-10CR .045” CRZR Contact Tip, 10-Pack K. 15040-16 16’ Steel Liner
C. 24106B Spot Weld Nozzle, 3-Pack L. 63160 Drive Roll f/Steel, .023”-.030”
D. 24104B Cylindrical Nozzle, 3-Pack K. 63498 Drive Roll f/Flux-Cored Wire