HTC 2500 iX, Manual

Page: 48 / 391

40
Remember that the grinding tools may be very hot if the
machine has recently performed grinding work. The tools
can remain hot for a long period after the machine has
been used.
When replacing a tool, pay attention to the crushing risk
when folding the grinding heads up/down.
The HTC 2500 iX is equipped with our new patented tool
system with a registered design, EZchange™. This com
-
prises wings bearing diamond grinding tools. These wings
are folded down and slid into a tool holder, and then locked
in place with a few gentle taps with a non-recoiling rubber
mallet.
In order to install the grinding tool, this is moved, tilting for
-
wards slightly, down into the intended slits in the tool holder.
After this, the tool is slid forwards, out from the centre of the
tool holder, in accordance with Figure 1.
Then lock the tool into the tool holder by giving it a few light
taps with a rubber mallet, in accordance with Figure 2.
When releasing grinding tools in conjunction with replace
-
ment, the tool is released most easily with a few gentle
taps on the grinding tool with a rubber mallet. This is now
performed in the opposite direction. Strike the tool until it
releases, and then lift it out of its guide slot in the tool holder.
See Figure 3.
Figure 1. When
installing a grind-
ing tool, the tool
must first be slid
down into the tool
holder’s guide
slot.
Figure 2. With a
few light taps, it is
then possible to
lock the tool in the
tool holder using a
rubber mallet.
Figure 3. In order
to disconnect a
tool, tap the tool
gently so that its
locking devices
releases. Then
lift it up out if its
guide slot.
Operation
Tool replacement