HS Tarm 2000, Installation And Operation Manual

Page: 20 / 66

I
NSTALLATION (continued)
PAGE 16
___________________________________________________________________________________________________________________________________________________________________________________
Jacket and Door Assembly (continued)
3. Install the left front jacket panel into place (oil burner side). Attach to front panel,
using one (1) zip strip. Engage jacket with bracket on boiler base.
4. Install the left rear jacket panel using the following sequence:
a. Remove the four nuts and burner plate from the rear left side of boiler,
b. Install one door mounting gasket over the burner flange,
c. Place the left rear side panel into position and slide zip strip to fasten it to left front
panel. Engage the jacket panel with the bracket on the boiler base.
d. Place another door mounting gasket over the jacket (at burner flange), and
e. Re-install burner plate using four nuts--Hand tighten only.
5. Install right front jacket panel into place. Remove the access panel for the optional
Domestic Coil if it is to be installed. Engage jacket with bracket on boiler base.
6. Install right rear panel.
HINT: Be sure you have the flue outlet in its proper place prior to placing this panel.
NOTE: You may use either the right or the rear flue outlet, if you need separate flue outlets
for each fuel, contact Tarm USA, Inc.
7. Install rear jacket panel. Prior to placing this panel, remove the plug in tapping #4 if you
are using it as your drain/feed.
HINT: Heating the plug prior to attempting to remove it will make the job much easier.
8. Install top front and rear panels by putting into place and pressing downward.
9. Seal the door frames to the face of the boiler with Stovex or furnace cement using the
following procedure:
a. After thoroughly mixing the Stovex compound, place a bead of Stovex on the
boiler flanges and the doorframes. Install the front jacket panel. Mount the
doorframes in place by just catching the threads, leaving the door loose.
b. From inside the door opening force additional Stovex into the space between the
doorframes and the boiler.
c. Check for proper jacket alignment as you tighten the studs evenly. Excess Stovex
will be squeezed out leaving a perfect seal at the doors. Immediately wipe excess
cement from the jacket with a damp rag.
10. Attach the doors to the door frames by inserting the hinge pins. Install the round bakelite
knob on the secondary air control lever.
11. Tighten nuts on burner mounting plate (left side of boiler).
16