Photo 56
Repeat the entire process described in the last two paragraphs for each bolt plate
section, leap-frogging the assembly jigs at each step so that every bolt plate
section has a jig and shims aligning it at both ends while you tighten it down.
Once all the modular bolt plate sections on the vertical leg subassembly have
been secured tightly in place with the #10-24x3/4” screws, remove the VXR
modular bolt plate assembly jigs and the .01” metal shims and set them aside. Set
the completed vertical leg subassembly aside as well and repeat the entire leg
assembly/disassembly process as described starting at the fourth paragraph in
this “VXR Modular Leg Assembly/Extension” section for each leg of the frame
system you are altering. When all the vertical leg subassemblies are complete,
refer to the “Attaching the VXR Horizontal Crossmember Subassemblies” section
of this manual and follow the instructions to finish reassembling your HRS VXR
Audio Stand.
VXR Cable Organizer Accessory
-
The cable organizer system is available for the
VXR as an accessory. It bolts into the back of the VXR frame using the remaining
threaded holes in the VXR vertical leg subassemblies that are used to support the
isolation bases. They should be installed using the 1/4”-20x1/2" bolts supplied
with the organizers. The organizers are installed at a right angle to the vertical
leg subassemblies with the holes vertically aligned to pass the cables through in
an aligned and organized manner. Be
very careful
not to cross-thread the
fastener. The fastener should thread in very easily. If it does not, back it out and
start it in again. If necessary, loosen the other fasteners on the cable organizer
and move it to a position that allows all the screws to thread in with minimal
torque. Once all four screws on each organizer are engaged, hand-tighten the
screws using the ratchet wrench supplied with the VXR frame. The cable
organizer can also be used to support the weight of a network box for cables that
apply this approach.