Second VXR Vertical Leg Subassembly Installation
-
If you are assembling a
VXR frame system that is more than one column wide, use all the double-sided
vertical leg subassemblies (with bolt plates on two sides) before installing the
second set of one-sided subassemblies.
Carefully lower one leg onto the open side of the mount assemblies you already
installed (see Photo 16). Make sure the keys on the mount assemblies slot into the
keyway on the leg completely (see Photo 17). Note that the photographs here
show the installation of a one-sided vertical leg subassembly for a single-column
frame system. Make sure that if you are assembling a frame system with multiple
columns you install double-sided vertical leg subassemblies at this stage so that
the other columns can be built off of the first.
Photo 16
Photo 17
Install all the 1/4-20 x 3/4" screws on the third vertical leg subassembly (four at
each mount location) until they are fully engaged, but do not torque the screws
tightly at this time. As before, leave them 1/4 turn from fully tightened to allow a
very small amount of play to complete the balance of the assembly.
