Always remove all components and isolation bases from the frame system before
adjusting or removing any part of the VXR. Once the frame system and the area
around it are free of any objects that may damage or be damaged by the VXR,
prepare a work area the same as during initial assembly. Locate a very strong
and stable work surface capable of supporting at least twice the weight of the
completed assembly or an area on the floor that will provide a soft, scratch-
resistant workspace at least three feet by six feet in size. The more space you have
the better, as it will give you room to move around the frame to complete
assembly. It is important that the area be free of all dirt, screws or small pebbles,
and that it is covered with a clean soft protective blanket (min size 24" x 45") that
will prevent damage to the cosmetic surfaces of the VXR frame parts.
At least two people should work together to tip the VXR over onto one side in your
work area (see Photo 47). If you are working with a doublewide (or wider) stand,
perform the following disassembly instructions on the stand while it is upright,
but be very careful to support each vertical leg subassembly as you detach it so
that it does not tip over and damage itself, the rest of the frame system, or injure
any people. When only one column remains, two people can tip it over onto its
side and continue the instructions as normal.
Photo 47
Use the 5/32” T-wrench and ratchet wrench to remove the four 1/4”-20x3/4”
screws that connect each leg to the horizontal crossmember assembly at each
level of the stand. Once all the screws have been removed, two people should
work together to carefully lift the legs off the stand and place them in your
prepared work area (see Photo 48).