VDPL300SC
27.09.2011
©Velleman nv
4
light output and any illuminated surface.
•
Use an appropriate safety cable to fix the device (e.g.
VDLSC7
or
VDLSC8
).
•
Familiarise yourself with the functions of the device before actually using it. Do not allow
operation by unqualified people. Any damage that may occur will most probably be due to
unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used… Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5. Operation
Switch on your
ARAZU
I
by connecting the power plug to
the mains. Disconnect from the mains to switch off. Select
with UP/DOWN, confirm your selection with ENTER.
•
Sound/Master-Slave Operation
Interconnect the master
ARAZU
I
and the slave
ARAZU
I
s using standard DMX cables through the XLR inputs and
outputs. Attribute the G.1 address for the master unit;
attribute an S.x address for any slave unit. The units will
now react to sound.
•
DMX512 Control
Operating the
ARAZU
I
through a DMX controller allows you to create your own tailored programs
and to control each connected
ARAZU
I
individually. Simply connect the controller to the
ARAZU
I
using a standard DMX cable. Press MODE until R.XXX is displayed. Next, set the DMX address for each
ARAZU
I
.
o
Detailed DMX Values per Channel
CHANNEL FUNCTION
FROM
TO
DESCRIPTION
1 Shutter
0
255
From 0 to 100 %
2 Gobo
0 7
Gobo
1
8 15
Gobo
2
16 23
Gobo
3
24 31
Gobo
4
32 39
Gobo
5
40 47
Gobo
6
48 55
Gobo
7
56 63
Gobo
8
64 71
Gobo
9
72 79
Gobo
10
80 87
Gobo
11
88 95
Gobo
12
96 103
Gobo
13
