HPEVS Curtis 1239 E, Electrical Schematics And Documentation, Page: 32 / 57

32
ADDITIONAL NOTES
Setup for Type 4 WigWag Throttle
1: Using a handheld Programmer or the 1314 Programming Station, Go to "Monitor", then "Inputs" and
note at the Throttle Pot Voltage reading with the throttle in the neutral, full forward and full reverse
positions. If the Throttle voltage is lower in the forward direction than in the reverse direction, swap the
outer two legs of the throttle pot.
2: Set the Forward Deadband parameter to .1 volts higher than the value noted.
3: Set the Reverse Deadband parameter to .1 volt less than the value noted.
4: Set the Forward Max parameter to .1 volt less than the full forward throttle voltage noted.
5: Set the Reverse Max parameter to .1 volt higher then the full reverse voltage noted.