HPE Synergy 12000 Frame, Maintenance And Service Manual

Page: 58 / 141

Removing and replacing a device bay blank Removing and replacing a device bay blank
Install device bay blanks in any unused device bays.
To remove the component, use the pull slots to remove the device bay blank.
To replace the component, reverse the removal procedure.
If replacing a full-height device bay blank, ensure that the coupler is installed:
Procedure Procedure
1. Fit the coupler plate into the slots on top of the blank, and then slide the coupler plate back until it snaps into place.
2. Fit the slots on the bottom of the second blank on to the coupler plate tabs. Then, slide the second blank forward until it snaps in
place.
Removing and replacing a device bay blank 58