HPE ProLiant DL325, Maintenance And Service Manual

Page: 64 / 144

To replace the component, reverse the removal procedure.
Removing and replacing the iLO Service Port assembly in
SFF
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack .
• Remove the server from the rack .
5. Remove the access panel .
6. Remove the SFF front I/O assembly .
7. Remove the iLO Service Port assembly in SFF.
a. Remove one T-15 screw.
b. Remove the iLO Service Port assembly.
64 Removal and replacement procedures