HPE ProLiant DL325, Maintenance And Service Manual

Page: 61 / 144

Procedure
1. If installed, remove the bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack .
• Remove the server from the rack .
5. Remove the access panel .
6. Disconnect the following cables from system board:
• Front I/O cable
• iLO service port cable
• USB 3.0 cable
7. Release all front I/O assembly cables from clips.
8. Remove the front I/O assembly.
a. Detach the ambient thermal sensor cable from its clip.
b. Remove one T-10 screw
c. Remove the front I/O assembly
9. Remove the USB 3.0 cable assembly.
Removal and replacement procedures 61