If
NONE
is specified instead of a cap wattage value, then APM removes all (or the specified zone) of the power caps.
To remove baseline data from the EEPROM and to remove the power cap setting, enter the following command:
>SET POWER BASELINE NONE
After this command is issued, the only way to re-establish a power baseline is to issue the
SET POWER BASELINE
command. The system returns to the default power cap mode (mode 1).
Remove the front bezel
Procedure
1. If installed, unlock and remove the bezel lock or Kensington security lock.
For more information, see the lock documentation.
2. Remove the front bezel.
Remove the hot-plug drives
CAUTION: To prevent improper cooling and thermal damage, do not operate the chassis unless all bays are
populated with a component or a blank.
Remove the LFF hot-plug drive
Procedure
1. Back up all server data on the drive.
2. If installed, remove the front bezel.
3. Determine the status of the drive from the drive LED definitions.
4. Press the latch to open the release lever.
5. Pull the release lever to disengage the drive from the backplane, and then slide the drive out of the bay.
Operations
28
