68
M 322
Operator Manual
tyre and on the tyre surface. Wear protective goggles with OSHA, CE approval or other
certified devices during all work phases.
10. Always carefully inspect the machine before using it. Missing, damaged or worn equip-
ment (including the hazard labels) must be repaired or replaced before start-up.
11. Never leave nuts, bolts, tools or other materials on the machine. They could remain
trapped in moving parts and cause malfunctions or be projected
out of the machine.
12. DO NOT install or inflate tyres that are cut, damaged, decayed
or worn. DO NOT install tyres on damaged, bent, rusted, worn or
deformed rims
13. If the tyre is damaged during the mounting phase, do not try to
complete the mounting operation. Remove it and take it away from
the service area, marking it as damaged.
14. Inflate the tyres slowly, in steps, while checking the pressure, the tyre, the rim and
the bead. NEVER exceed the pressure limits indicated by the manufacturer.
15. The internal parts in this machine could create contacts or sparks if exposed to flam-
mable vapours (petrol, paint thinner, solvents, etc.). Do not install the machine in a
narrow area or below floor level.
16. Do not operate the machine while under the influence of alcohol, medicine or drugs.
If you are taking prescription or non-prescription medicine, contact a physician to
understand the side effects that the medicine could have on the ability to operate
the machine safely.
17. Always use OSHA, CE approved and authorised personal protec-
tive equipment (PPE) or equipment with equivalent certification
while operating the machine. Consult your supervisor for additional
instructions.
18. Do not wear jewellery, watches, loose clothing, ties and tie back
long hair before using the machine.
19. Wear protective, non-slip footwear while using the tyre changer.
20. While positioning, lifting or removing wheels from the tyre changer,
wear a suitable back support and use a correct lifting technique.
21. Only suitably trained personnel can use, service and repair the
machine. Repairs may only be performed by qualified personnel.
SIMPESFAIP technical personnel are the most qualified individuals.
Employers must determine if an employee is qualified to carry out
any machine repair safely if the operator has attempted to make
the repair.
22. The operator must pay close attention to the warnings on the
equipment labels before starting the machine.
23. Clamp the rim on the wheel support plate during inflation.
Summary of Contents for M 322
