Troubleshooting
149
Tr
oubleshooting
My remote control
doesn’t work.
■
Check that the remote control indicator light on the remote lights up when you
press a button. If it does not, replace the batteries.
■
Make sure that the batteries for the remote control are charged and installed
correctly.
■
Make sure the front of the remote sensor on the HP Digital Entertainment Center is
not blocked (behind display window).
■
Point the remote control at the HP Digital Entertainment Center (not at the TV)
within a 45-degree angle range, and less than 26 feet (8 meters) away.
■
If a pressed key repeats itself (or sticks), try altering the lighting conditions in the
room or moving the location of the HP Digital Entertainment Center.
■
Press the Enter button on the remote control after changing a channel.
■
Point the remote control toward the remote sensor, and press a button. A faint red
light should appear on the remote sensor. If the light appears, then the problem
is probably in the Media Center software. Close Media Center, restart the
HP Digital Entertainment Center, and then open Media Center again.
■
If the remote control works in Media Center but not when changing channels, you
need to reconfigure the Media Center software settings for the cable set-top box
or satellite receiver. Refer to the
Software Guide
.
My remote sensor
is not receiving a
signal from the
remote control.
If a faint red light does not appear when you point the remote control at the front
panel remote sensor and press a button, try the following:
■
Check that the remote control indicator light on the remote lights up when you
press a button. If it does not, replace the batteries.
Or
1
Click
Start
on the desktop, right-click
My Computer
, and then select
Properties
.
2
Click the
Hardware
tab, and then click
Device Manager
.
3
Click the plus (
+
) sign next to Universal Serial Bus Controllers.
4
If the
eHome Infrared Receiver
is listed under Universal Serial Bus Controllers,
Windows is properly detecting the IR receiver. If it is not listed, go to the next step.
5
Turn off the HP Digital Entertainment Center. Remove all external USB devices.
Remove the power cord for 30 seconds. Then reconnect external devices and
power. Repeat steps 1–4.
Problem
Solution
Summary of Contents for z540
