HP V1910, User Manual

Page: 38 / 483

26
Description
Use the upgrade server-address source-filename bootrom command to upgrade the Boot ROM image. If the
Boot ROM image in the downloaded software package file is not applicable, the original Boot ROM image
is still used as the startup configuration file.
Use the
upgrade server-address source-filename runtime command to upgrade the system software image
file. If the system software image file in the downloaded software package file is not applicable, the original
system software image file is still used as the startup configuration file.
To make the downloaded software package file take effect, reboot the device.
NOTE:
The HP V1910 Switch Series does not provide an independent Boot ROM image; instead, it integrates the
Boot ROM image with the system software image file together in a software package file with the
extension name of
.bin .
Examples
# Download software package file main.bin from the TFTP server and use the Boot ROM image in the
package as the startup configuration file.
<Sysname> upgrade 192.168.20.41 main.bin bootrom
# Download software package file main.bin from the TFTP server and use the system software image file in
the package as the startup configuration file.
<Sysname> upgrade 192.168.20.41 main.bin runtime
Configuration example for upgrading the system
software image at the CLI
Network requirements
As shown in a , a V1910 switch is connected to the PC through the console cable, and connected to the
gateway through GigabitEthernet 1/0/1. The IP address of the gateway is 192.168.1.1/24, and the TFTP
server where the system software image (
SwitchV1910.bin ) is located is 192.168.10.1/24. The gateway
and the switch can reach each other.
The administrator upgrades the Boot ROM image and the system software image file of the V1910 switch
through the PC and sets the IP address of the switch to 192.168.1.2/24.
a.
Network diagram for upgrading the system software image of the V1910 switch at the CLI
Configuration procedure
Table 13 Run the TFTP server program on the TFTP server, and specify the path of the file to be loaded.
(Omitted)
Table 14 Perform the following configurations on the switch.