Installing and Configuring the Director
47
Director 2/140 Installation Guide
2. Along an exterior vertical rail of the rack cabinet, determine the position of
the bottom of the shelf bracket and count 1U up from this location.
3. Use a straight edge to locate the corresponding rack holes along the interior
vertical rails of the rack cabinet. Mark this location on each interior vertical
rail.
4. Install two cage nuts along one interior vertical rail as marked in
step 3
,
leaving one empty rack hole between the cage nuts.
5. Repeat
step 4
for each of the three remaining interior vertical rails.
6. Secure a shelf bracket to the interior vertical rails using four (4) Phillips
panhead screws with split lock and flat washers.
7. Repeat
step 6
to secure the second shelf bracket on the opposite side of the
rack.
8. Continue to “
Attaching the Mounting Hardware to the Director
Attaching the Mounting Hardware to the Director
Use these steps to secure the mounting hardware to the director.
Note:
All mounting brackets are attached to the director using 10/32 x 3/8-inch
flathead countersunk Phillips screws.
1. Locate the two front mounting brackets in the shipping carton.
2. Secure the front mounting brackets on either side of the director, as shown in
. For each front mounting bracket, use three (3) screws.
