Removal and Replacement Procedures
Drive Fan Cable and Cable Bracket
To remove the drive fan cable and cable bracket:
1. Prepare the server for a non-hot-plug procedure. Refer to “Preparing the Server for
Non-Hot-Plug Procedures” in this chapter.
2. Remove the front bezel door (tower model only), and lay the server on its side with the
access panel facing upward. Refer to “Removing the Front Bezel Door (Tower Model
Only)” in this chapter.
3. Remove the access panel. Refer to “Removing the Access Panel” in this chapter.
4. Remove the hot-plug fans. Refer to “Hot-Plug Fans (Processor and I/O)” in this chapter.
5. Remove the fan baskets. Refer to “Fan Basket” in this chapter.
6. Remove the hot-plug drive fans. Refer to “Hot-Plug Fans (Drive)” in this chapter.
7. Remove the drive air baffle. Refer to “Drive Air Baffle” in this chapter.
8. Remove the drive cage. Refer to “Drive Cage Backplane” in this chapter.
9. Remove the Torx T-10 screw holding the drive fan cable bracket in place
(1),
and lift the
drive fan cable bracket from the chassis.
10. Disconnect the drive fan power cable from the power backplane
(2)
.
Figure 2-54: Removing the drive fan cable and cable bracket
11. Remove the drive fan cable from the unit.
Reverse steps 1 through 11 to replace the drive fan cable and cable bracket.
HP ProLiant ML570 Generation 2 Server Maintenance and Service Guide
2-63
Summary of Contents for ProLiant ML570 Generation 2
Page 6: ......
