HP ProLiant DL388e, User Manual

Page: 53 / 140

Hardware options installation 53
Fan population guidelines
Configuration Fan bay 1 Fan bay 2 Fan bay 3 Fan bay 4 Fan bay 5 Fan bay 6
One processor,
nonredundant
Blank Fan Blank Fan Fan Fan
One processor, redundant
Fan Fan Blank Fan Fan Fan
Two processor, nonredundant Fan
Fan Fan Fan Fan Blank
Two processor, redundant
Fan Fan Fan Fan Fan Fan
Installing a hot-plug fan module if the server is installed in a
ball-bearing rail system with the cable management arm
CAUTION: To prevent the potential for thermal damage and system shutdown, ensure that a
functioning server has all feature bays populated with the required component or blank and the
access panel is installed within 60 seconds of being serviced.
1.
Pull down the quick release levers on each side of the server.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
2.
Extend the server on the rack rails until the server rail-release latches engage.
If the server does not extend from the rack, use a T-25 Torx screwdriver to loosen the screws located
within the lever housing.
3.
Open the latch, slide the access panel to the rear of the chassis, and then remove the access panel.
If the latch is locked, use a T-15 Torx screwdriver to unlock the latch.
4.
Do one of the following: