Hardware options installation 63
•
Each channel can have a different valid online spare configuration.
•
Each populated channel must have a spare rank:
o
A single dual-rank DIMM is not a valid configuration.
o
LRDIMMs are treated as dual-rank DIMMs.
Installing a DIMM
1.
Power down the server (on page
18
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
18
).
o
Remove the server from the rack (on page
20
).
4.
Remove the access panel (on page
21
).
5.
Remove the air baffle (on page
22
).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
Install the air baffle (on page
22
).
9.
Install the access panel (on page
21
).
10.
Install the server into the rack ("
Installing the server into the rack
" on page
31
).
11.
Power up the server (on page
18
).
After installing the DIMMs, use RBSU ("
HP ROM-Based Setup Utility
" on page
103
) to configure the memory
protection mode.
Summary of Contents for ProLiant DL388e
