Removal and replacement procedures 47
IMPORTANT:
Processor socket 1 must be populated at all times or the server does not function.
In a multiprocessor configuration, to optimize system performance, HP recommends balancing the total
capacity of the DIMMs across the processors.
To remove the component:
1.
Power down the server (on page
29
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
30
).
o
Remove the server from the rack (on page
31
).
4.
Remove the access panel ("
Access panel
" on page
35
).
5.
Remove the heatsink ("
Heatsink
" on page
44
).
CAUTION:
The pins on the processor socket are very fragile. Any damage to them may require
replacing the system board.
6.
Open each of the processor locking levers in the order indicated, and then open the processor retaining
bracket.