Removal and replacement procedures 46
c.
Finish the installation by completely tightening the screws in the same sequence.
4.
Install the access panel.
5.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Processor
The server supports single-processor and dual-processor operations.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION:
To prevent possible server overheating, always populate processor socket 2 with a
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT:
If installing a processor with a faster speed, update the system ROM before
installing the processor.
