HP ProCurve 6108, Management And Configuration Manual

Page: 350 / 547

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1D Spanning-Tree Protocol (STP)
Terminology
Term Definition
downlink port A switch port that is linked to a port on another switch (or to an end node) that is sequentially
(downstream port)
further away from the STP root device. For example, port "C" in figure 14-11, above, is a
downlink port.
edge switch For the purposes of fast-uplink STP, this is a switch that has no other switches connected to
its downlink ports. An edge switch is sequentially further from the root device than other
switches to which it is connected. Also termed
wiring closet switch
or
leaf switch
. For
example, switch "4" in figure 14-12 (page 28) is an edge switch.
interior switch In an STP environment, a switch that is sequentially closer to the STP root device than one
or more other switches to which it is connected. For example, switches "1", "2", and "3" in
figure 14-12 (page 28) are interior switches.
single-instance spanning A single spanning-tree ensuring that there are no logical network loops associated with any
of the connections to the switch, regardless of whether there are any VLANs configured on
the switch. For more information, see "Spanning Tree Protocol (STP)" in chapter 9, "Configuring
Advanced Features", in the Management and Configuration Guide for your switch. tree
uplink port
(upstream port) A switch port linked to a port on another switch that is sequentially closer to the STP root
device. For example, ports "A" and "B" in figure 14-11 on page 27 are uplink ports.
wiring closet switch Another term for an "edge" or "leaf" switch.
When single-instance spanning tree (STP) is running in a network and a
forwarding port goes down, a blocked port typically requires a period of
(2 x (
forward delay
) + link down detection)
to transition to forwarding. In a normal spanning tree environment, this
transition is usually 30 seconds (with the
Forward Delay parameter set to its
default of 15 seconds). However, by using the fast-uplink spanning tree
feature, a port on a switch used as an
edge switch can make this transition in
as little as ten seconds. (In an STP environment, an edge switch is a switch
that is connected only to switches that are closer to the STP root switch than
the edge switch itself, as shown by switch "4" in figure 14-12, below.)
Switch
4
(Edge)
Switch
3
Switch
1
(Root)
Switch
2
Port 3
Port 5
Link blocked by STP:
1
6
8
LAN
Figure 14-12. Example of an Edge Switch in a Topology Configured for STP Fast Uplink
In figure 14-12, STP is enabled and in its default configuration on all switches,
unless otherwise indicated in table 14-5, below:
14-28