HP ProCurve 6108, Management And Configuration Manual

Page: 343 / 547

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1D Spanning-Tree Protocol (STP)
CLI: Configuring 802.1D STP
STP Commands Used in This Section
show spanning-tree config Below
spanning-tree
protocol-version page 14-22
forward-delay
<4 - 30>
page 14-23
hello-time
<1 - 10>
page 14-23
maximum-age
<6 - 40>
page 14-23
priority
<0 - 65535>
page 14-23
ethernet
<port-list>
page 14-24
path-cost
<1 - 65535>
page 14-24
priority
<0 - 255>
page 14-24
mode
<norm | fast>
page 14-24
show spanning tree Lists additional STP data not covered in this chapter. See
“Spanning Tree Protocol (STP) Information” on page B-17
Viewing the Current STP Configuration. Regardless of whether STP is
disabled (the default), this command lists the switch’s full STP configuration,
including general settings and port settings.
Syntax
:
show spanning-tree config
When the switch is configured for 802.1D STP, this command displays infor­
mation similar to the following:
Command Listing when
STP is the Protocol Version
(See also page 14-10
Figure 14-9. Example of the Default STP Configuration Listing with 802.1D STP
Configured at the Protocol Version
14-21