HP P9000, Reference Manual

Page: 191 / 399

Table 101 Configuration Files That Must Be Loaded Before Command Execution (When the
Environment Contains a Non Gen'ed Volume) (continued)
Configuration file that must be loaded Command name
Path set definition file Route list definition file Copy group definition file
-- D
2
Y
YKMAKE
-- -- --
YKQHPATH
-- Y --
YKQRYDEV
Y D
1
--
YKQRYPTH
-- D
2
Y
YKQUERY
-- Y Y
YKRECVER
-- D
2
Y
YKRESYNC
-- -- Y
YKRUN
-- -- --
YKSCAN
-- -- --
YKSLEEP
-- D
2
Y
YKSTATS
-- D
2
Y
YKSUSPND
-- -- --
YKWATCH
-- -- --
YKWTOMSG
1 You need to load the configuration file when operating a forward-direction path (a path from a P-VOL whose copy
type is CAJ to an S-VOL). You also need to load the configuration file if all of the volumes in the CU are Non Gen'ed
volumes when operating an inter-CU logical path.
2 You need to load the configuration file when the copy type is CAJ.
Legend:
Y: You need to load the configuration file.
D: Whether you need to load the configuration file depends on the situation.
--: You do not need to load the configuration file.
Command details
This section describes command details. For details about the syntax symbols used in the
explanations, see
“Symbols Used in Syntax Explanations” (page 383)
YKBLDCMD Command
Applies to CMD.
Format
YKBLDCMD
1
SN(storage system-serial-number)
1
MSG(stem-name-1)
Function
This command is a TSO/E command called from REXX scripts.
The command registers, into the storage system, the command device that was specified in the
route list that was loaded before this command was executed.
Command details 191