HP NonStop SSH 544701-014, Reference Manual

Page: 57 / 344

HP NonStop SSH Reference Manual Configuring and Running SSH2
•
57
$0
Specifies that audit messages are written to $0.
auditdevice
Log messages are written the given device (e.g. $DEV.#SUBDEV).
Default
By default, no audit messages will be written ("*").
Considerations
•
Although it is possible to specify a collector setting AUDITCONSOLE to a collector name is not recommended
because a collector will cut long messages after 108 characters.
•
If writing audit messages to a collector is required, then use parameter AUDITEMS instead.
See also:
•
AUDITEMS, AUDITFILE, AUDITFORMATCONSOLE
•
"Audit Messages" in chapter "Monitoring and Auditing"
AUDITEMS
Use this parameter to define whether SSH2 audit messages are written to EMS.
Parameter Syntax
AUDITEMS collector | *
Arguments
*
Means that no audit messages are written to EMS.
collector
Specifies the name of the collector to which audit messages are written.
Default
By default, no audit messages are written to EMS ("*").
Considerations
•
The AUDITFORMATEMS parameter controls the log message format.
•
The parameter can be changed without having to restart SSH2, using the SSHCOM command interpreter
(command SET AUDITEMS).
•
To send audit messages to the default collector $0 use AUDITEMS $0.
•
If the EMS collector specified cannot be opened during startup, SSH2 will write to the collector $0.
•
If the EMS collector cannot be opened after it has been changed through SSHCOM, the original collector will
stay active.
See also:
AUDITFORMATEMS