Chapter 4
Diagnostics
38
Code
Description
Problem/Solution
0600
Video Memory boot
error
The video memory size detected during POST is smaller than
previously detected. (This would apply if the embedded video
circuitry was defective, or a video adapter board were installed into
LP 2000r to increase the video speed and memory.)
To correct this:
1. If you have changed to a video adapter board, press
[F4]
to
automatically validate the change.
2. If the problem persists, the system board or video board may
need to be replaced. Contact your service representative.
0700
DIMM size boot error
POST has detected system memory size is smaller than previously
detected. At least one or several DIMMs are disconnected, or have
been replaced by smaller ones.
To correct this:
1. If some DIMMs have just been removed or replaced by
smaller ones, press
[F4]
to automatically validate the change.
2. If no DIMM has been removed or changed, ensure all DIMMs
are properly inserted in the slots.
3. If the problem persists, one of DIMMs may need to be
replaced. Contact your service representative.
0712
DIMM installation
error
POST has detected an incorrectly installed DIMM or the failure of
one or more DIMMs.
To correct this:
1. If additional memory was just installed in your Netserver,
please verify the installation conforms to the description in
the User's Guide.
2. If this error was reported when no additional memory was just
installed, restart the Netserver.
3. If the error persists, contact your service representative.
0713
Incorrect DIMM
installed
POST has detected one or more DIMMs are not the correct type, or
the correct speed.
To correct this:
1. If additional memory was just installed in your Netserver,
please verify the correct DIMM type and speed for this
Netserver was installed.
2. If this error was reported and no additional memory was just
installed, restart the Netserver.
3. If the error persists, contact your service representative.
0800
Cache memory size
error
POST has detected the cache memory size is smaller than
previously detected.
To correct this:
1. If the processor has just been replaced, press
[F4]
to
automatically validate the change.
2. If the problem persists, the processor may need to be
replaced.