HP J4819A, Installation And Getting Started Manual

Page: 58 / 108

3-12
Getting Started With Switch Configuration
Configuring the ProCurve Wireless Edge Services xl Modules (J9001A, J9003A)
Ge
ttin
g
Sta
rte
d
With
Sw
itc
h
Co
nf
ig
u
rat
io
n
The following example enters the wireless services context of a module
installed in Slot B of a 5300xl switch and then displays the IP address assigned
by DHCP to the module:
If no DHCP service is available or if the administrator wishes to manually set
the Wireless Edge Services xl Module IP Address, it can be specified using the
CLI. From the wireless services context, enter the config context and then
configure the
vlan1
interface. Use the following command to set the IP address:
ProCurve(wireless-services- <slot-id> )(config-if)# ip address <IP>
where
<slot-id>
is the slot in the 5300xl where the module is installed.
where
<IP>
is the IP address in CIDR notation (/mask bit number) or
dhcp
which uses a DHCP client to obtain an IP address.
In the following example, the CLI commands set the module’s IP address to
10.245.22.14 with a 21-bit subnet mask.
If necessary, use the following command from the wireless services config
context to set or change the default gateway:
ProCurve(wireless-services-B)(config)#ip default-gateway <ip-addr>
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.1.
ProCurve# configure
ProCurve(config)# wireless-services b
ProCurve(wireless-services-B)#show ip interface
Interface IP-Address Status Protocol
vlan1 10.35.12.24(DHCP) up up
ProCurve(wireless-services-B)#
ProCurve(wireless-services-B)#configure
ProCurve(wireless-services-B)(config)#interface vlan1
ProCurve(wireless-services-B)(config-if)#ip address 10.245.22.14/21
ProCurve(wireless-services-B)(config-if)#show ip interface
Interface IP-Address Status Protocol
vlan1 10.245.22.14 up up
ProCurve(wireless-services-B)(config-if)#