HP J4819A, Installation And Getting Started Manual

Page: 35 / 108

2-15
Installing the Switch 5300xl Series
Installation Procedures
In
st
a
lli
n
g
the
S
w
itch
5300xl
Se
ries
2. Partially install a screw (5/8-inch number 12-24) into the top hole of a pair
of holes that are 0.5 inches apart in each rack/cabinet upright as shown
in the illustration below. Ensure that the screws are at the same level in
each upright.
.
Figure 2-8. Partially installed screw for bracket notch
3. Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
Figure 2-9. Setting the bracket notch
partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
lower the switch with
mounting brackets onto the
partially installed screws,
then tighten these screws